Cap might be on for the last time. Sadly, I've got this pulley/winch thing down - dropped the cap on in 10 minutes solo. Finished the new playpen supports and divider for the relocated batteries. Ran all new wires on the top cap. Cut out a hole for the newly insulated ice chest (but admittedly had to go back and trim 1/2" of insulation from 2 corners to make it fit). Laid new carpet.
Decided to keep the "green, not gray" bilge, but need to trim the 2 floor panels to get a tight fit on the seams before carpeting them.
Next up - start the daunting task of cosmetics on the hull (gelcoat repair is not my specialty - got a buddy that might help out). Probably wetsand until my shoulders give out & then switch to engine detail (carb rebuild, electronic ignition, paint, etc.) and mechanicals, then back to wetsanding, & repeat.
Reply With Quote
