'87 Supra Saltare "Rebuild"- Keep the Big Girls Running!!

[sybrmike]

Looking good! I thought about a carpetless textured gel floor as well, but didn't think my gel skills were adequate to get a good finish - I've heard the patterned mat used to get the nonskid surface can be tricky to work with. But in the hands of some pros, that'd be slick (well, not slick but cool).

I can make out just a little of the aluminum intake on the engine - is that an air gap like mine? Any problems getting brackets & such to fit? Can't wait to see the reconfigured rear seating.

[Okie Boarder]

Looks good. Almost done!

[Rusty]

Ya...it looks very raw. I was reassured it was resined quite well.

Looking really good!! The foam is a controversial topic. I replaced it when I rebuilt mine (more for support of the floor than anything else) but if I did it again, I don't think I would.

the only thing I'm curious about is... did you not fiberglass or CPES the bottom of the floor? the plugs that came out look awfully raw on the bottom!

[Rusty]