I have two batteries on a perko switch. Is there anything wrong with switching from battery one to battery two or both while the motor is running? Thanks for all the help on the forum.
Scott
I have two batteries on a perko switch. Is there anything wrong with switching from battery one to battery two or both while the motor is running? Thanks for all the help on the forum.
Scott
No problem - The Perko switch is a "make before break" type switch. You will simply have both batteries connected momentarily before "switching" to the other. The "ALL" position is between position 1 and 2.
Anybody have a diagram on how to wire 2-batts and a pergo switch. I dont even know how much wire to buy. Thanks Jet
Last edited by jet; 08-26-2011 at 04:38 PM.
89' Comp rebuild thread:
https://www.facebook.com/andrewjetm/...1923456&type=3
89' Comp Mod's and fun pic's:
https://www.facebook.com/andrewjetm/...6666464&type=3
89' Supra/Custom Tower & Interior/Swivel Racks
4 Blade-14X14/1600 lbs Ballast
Roswell Bar/Led's/Krypt 6.5 HLCD's/Krypt 4200 Eq
JL-Kicker Amps 2000 Watts/Kicker Interiors/L7 Kicker Sub
Jet -
Ground just requires a jumper from one battery to the other and your existing ground wired to just one battery. Then you'll run a hot cable from each battery to the switch, and another hot cable from the switch to your starter solenoid. So really there's just a minimal amount of additional cable from what you already have for one battery. Ground is common and you're swithching the hot. I used #2 welding cable to make mine custom fit.
Clint
That sounds easy..thanks C
89' Comp rebuild thread:
https://www.facebook.com/andrewjetm/...1923456&type=3
89' Comp Mod's and fun pic's:
https://www.facebook.com/andrewjetm/...6666464&type=3
89' Supra/Custom Tower & Interior/Swivel Racks
4 Blade-14X14/1600 lbs Ballast
Roswell Bar/Led's/Krypt 6.5 HLCD's/Krypt 4200 Eq
JL-Kicker Amps 2000 Watts/Kicker Interiors/L7 Kicker Sub