Wet Sanding?..... I need it. :S

[wiatowski]

For the small detail work I used a small flexible sanding block/pad and just my fingers in some cases.

I was thinking of the groove that goes around the boat... did you sand it just in a straight line?

Thanks for the in put... Have about another month before I put it in the water. Have to put new boards on the dock, and wet sand the boat, change the oils, give her a tune up, and put on the tower when it comes.
Think I'll remove the decals... but I have an Idea for putting different ones on. I won't say what it is unless I don't do it, but I post some pics either way.
They just peel off I assume? Suggestions for easier removal welcome.

Keep the suggestions coming.... So everyones has done this by hand? Was thinking of trying an orbital sander on the Transom below the water line.. keeping the hull nice and wet while I sand.... any thoughts?