Once you are able to slide the light in from the back, it should look like this:



Now your LED will fit in the housing, from the back, without having to modify the seat brackets, make new holes or anything. It will look factory original, until you turn on the lights.

I put a small bit of silicone on the lights to help hold them in place. Light weight silicone so I can pull them apart if I need to. Which I will be doing, I want a different color.



I didn't get any of them actually in the boat, I will tonight and update for reference.




Now, moving on to the boats with Lights underneath their cupholders. Those of you who have these know what I'm talking about. They have a switch to cut them off at the light, but are master controlled by the one switch in the dash. Now I opted to run my interior light in the helm to those cupholders, allowing me to turn on the floor lights, and the cupholder lights separately. The wiring is up to you.

Those who have them, here is what your brackets should look like. Boring, rough looking old lights.