Once you have all four of the light brackets out, begin your disassembly of the light brackets. I removed my switches to be able to wire directly to my LEDs so I could control them from the front. You can choose to leave yours if you would like them to be controlled by the switch at the bracket.

To remove the lights, you will have to pry up all the little tabs holding it in place.



Once all done, it should look like this. A clean bracket with nothing in it:




A BRIEF TANGENT!::::::::::::::::::::
While doing this I also drilled a small hole for a smaller LED from Oznium. I chose a different color (red) This would allow me to turn off my bright blue lights if it was really dark, and switch to red. This would give my passengers light, while not blinding me while I drive. Red is better for night time driving.


Now, with the old bracket empty, here's the tricky part...........................................jus t slide the new LED into place! They fit PERFECTLY!!! No cutting required. I dropped mine in, and just used duct tape to hold them in place on the backing.