The aluminum was a left over valance for a shower enclosure that I cut too short. I have had it in my garage for 3 years now and don't know how many times I have almost thrown it away. I had to notch out about 3/8th inch on the front side of it to make room for the middle platform bracket since the three brackets aren't in a straightline. I had to slip it into the middle one and through the far one then install the closest bracket. When screwed down the aluminum is bound in there and has no fasteners. I drilled out a hole in the middle of the drain plug and ran the wires through it to keep no holes in the back. 3M 5200 bonds the LED's to the aluminum and also seals the wire within the drain plug. All are shrinked wrap for protection. I used thermostat wire to feed power to it from a dimmer switch mounted in the drivers area. All nine lights pull less than 1 amp.
Reply With Quote
