Ontarion
Member

No problem John. I am not that big of a forum poster myself. The Rex mufflers worked out great. I did not remove the rub rails. Was able to remove a lot of the old silicone with rail on. Then recalked. Took about 2to 3 hrs. Never got the tower. A guy I work with sold me a barefoot international fly high extended pole. With 2 quick release racks for $200 It gets the skis and boards off the floor. And comes down quickly when I put the boat back on the lift with the canopy. Very happy with it. I didnt think I would like it. But it works and looks better then I thought. Have a great day.

Hi John. Is it getting warm enough to start thinking about boating up there yet. Quick question. When you put the rexmar silencers and new hose on. Did you have to remove the risers. Or did you have enough play in the 3 1/2 hose to fit them in. Thanks

Thanks John. I was able to pull the hose out from under the trans. Must have gotten wedged under there over the years. My only problem is I cant get 1/2 inch drive on the manifold plug because my mufflers are in the way. If I pull the riser off the manifold to get to it. Is there a gasket between them I need to replace?

Hows it going Ontarion? Quick question. The raw water intake hose that runs from the hull. Then underneath the trans to the trans cooler. Is yours stuck underneath the trans? Mine is. I guess I could try to force it out from there. But then it might rub on the shaft. Just wondering if that is how it supposed to be. Was going to disconnect from the hull to suck up antifreeze to winterize. But since its stuck under the transmission. I will have to make a seperate hose from the top of the trans cooler to reach a bucket. Thanks.

Thanks for all your help. And for the contacts.

Ontarion. Whats the part# for the fuel sending unit from skidim.com. I wasnt sure which one. Also. Can you replace it through the inspection cover. Or do you have to pull the tank. Thanks.