i need a shift unit and handle. Been looking online but can not find one the is all alum. or metal for my 1985 supra. someone please help the only one i could find is this http://www.skidim.com/prodinfo.asp?number=MV3 .
i need a shift unit and handle. Been looking online but can not find one the is all alum. or metal for my 1985 supra. someone please help the only one i could find is this http://www.skidim.com/prodinfo.asp?number=MV3 .
I think which are asking about is called the morse control. What is wrong with yours? Most of the time all that goes bad is the grease. It’s likely you could take it apart clean it apply new grease you should be just fine. My 86 comp has over 1700 hours on it. A couple of years ago I was thinking about replacing mine and the guys at the boat shop told me that these units don’t wear out very often. Try cleaning yours up first. I think they cost around 3 to 400 dollars.
"Where There's a Will, there's a way!"
Check out my 1987 rebuild thread here
https://forum.supraboats.com/showthr...-Resto-begins.
I used a high temperature grease that I picked up at Napa. Any Greece should work. I know the unit gets hot in the sunshine and I thought that using a high temperature grease might lessen the chance of Greece the leaking out down the inside of the boat. As far as putting it back together you're on your own. But there's a good chance that someone on this form will step in and help you out. Good luck
there are little brass pieces that can get worn too. once they wear out, you can't move the throttle.
http://www.skidim.com/prodinfo.asp?number=R024024