Have a 96 ts6m comp with the 5.8 gt40. I am looking at the raw water intake hose going from the hull to the trans cooler. The hose routes from the hull. Then uderneath the transmission. Then loops back over the trans to the trans cooler. It looks like when they lined up the trans with the drive shaft. The hose got pinched under the transmission. It is not collapsed. But stuck under there pretty good. I can probably pry the hose out without damage. But then it will run at the rear of the trans. Worried it might contact the drive shaft If I leave it there. So I am wondering if after I pry it out. Should I unhook from the hull and route in front of the trans toward the engine. And connect back to the hull. Thanks.